Q-Logic IB6054601-00 D Bedienungsanleitung PDF herunterladen (Seite 28)

2 – InfiniPath Cluster Administration

Configuration and Startup

2-10 IB6054601-00 D

Check each of the lines starting with SUBSYSTEM=, to find the highest numbered

interface. (For standard motherboards, the highest numbered interface will

typically be 1.)

Add a new line at the end of the file, incrementing the interface number by one.

In this example, it becomes eth2. The new line will look like this:

SUBSYSTEM=="net", ACTION=="add", SYSFS{address}=="$MAC",

IMPORT="/sbin/ rename_netiface %k eth2"

This will appear as a single line in the file. $MAC is replaced by the string from

step 2 above.

4. Create the network module file:

/etc/sysconfig/hardware/hwcfg-eth-id-$MAC

Add the following lines to the file:

MODULE=ipath_ether

STARTMODE=auto

This will cause the ipath_ether Ethernet driver to be loaded and configured

during system startup.

5. Create the network configuration file:

/etc/sysconfig/network/ifcfg-eth2

If you are using DHCP (dynamically assigned IP addresses), add these lines

to the file:

STARTMODE=onboot

BOOTPROTO=dhcp

NAME=’InfiniPath Network Card’

_nm_name=eth-id-$MAC

Proceed to Step 6.

If you are you are using static IP addresses (not DHCP), add these lines to the

file:

STARTMODE=onboot

BOOTPROTO=static

NAME=’InfiniPath Network Card’

NETWORK=192.168.5.0

NETMASK=255.255.255.0

BROADCAST=192.168.5.255

IPADDR=192.168.5.211

_nm_name=eth-id-$MAC

Make sure that you substitute your own IP address for the sample IPADDR

shown here. The BROADCAST, NETMASK, and NETWORK lines need to

match for your network.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 121 122

Keine Kommentare

Q-Logic IB6054601-00 D Bedienungsanleitung Seite 28